31 Oct 2023
The most important step, cleaning your installed door. Watch this video from Dan to see why it's so crucial.
30 Oct 2023
Watch Dan install the door stay and grommets to finish the installation.
30 Oct 2023
Worried about blowing a brick? Teckentrup has a brilliant solution. Watch the video from Dan to see how this can be avoided.
30 Oct 2023
To get the perfect seal and eliminate play, adjusting the strike plate and keeps may be required. In this video, Dan shows you exactly how it's done.
30 Oct 2023
Flush bolts not engaging? Teckentrup have made adjusting the flush bolt plate simple. Here's Dan showing you how.
30 Oct 2023
In this video, Dan takes you through fixing the frame. No plugs are needed, just drive straight in!
30 Oct 2023
Watch how to check your door to make sure the door leaf edges are aligned and how to adjust them if needed.
30 Oct 2023
Watch step-by-step instructions from Dan on how to adjust the jacking bolts and level the frame on a Tekcentrup side hinged garage door. This step requires the use of wind bags to keep the door securely in place.
30 Oct 2023
Fitting the 3 part threshold is easy. Watch this quick video from Dan to see exactly how it's installed.
30 Oct 2023
Loosening the door jacking bolts before fitting the door in the opening makes using the allen key to adjust the bolts later on much easier. Here's Dan showing you how it's done.
30 Oct 2023
Next, it's time to prepare the door for installation by removing the threshold and lifting straps. Watch this video from Dan to see how quick and easy it's done.
30 Oct 2023
Stainless steel pull handles are fitted for you in the factory, but lever handles must be installed on site. Watch this video to see Dan take you through how to fit the exterior and interior lever handle.
Page 2 of 20